卡特彼勒CAT966G II裝載機保養時間查詢表
卡特彼勒CAT966G II裝載機保養時間查詢表
Maintenance Interval Schedule
966GII輪式裝載機操作及保養
注意：在使用機具或操作保養之前必須詳細閱讀所有安全信息，警告，和使用說明。
在間隔保養前，必須先完成之前間隔期內所須進行的保養。
AXJ00302 966GII WHEEL LOADER Operation & Maintenance
Media Number SEBU7458-05 Publication Date 2003/06/01 Update Date 2003/06/09
SMCS Code: 7000
Note: All safety information, warnings, and instructions must be read and understood before you perform any operation or any maintenance procedure.
Before each consecutive interval is performed, all of the maintenance requirements from the previous interval must also be performed.
在需要時進行
電池 --回收
電池或電池電纜--檢查/更換
鏟斗磨損--檢查/更換
斷路器--重置
發動機空氣濾清器（第一級）--清潔/更換
發動機空氣濾清器（第二級）--更換
發動機空氣初濾器--清潔
燃油系統--加油
保險絲--更換
液壓油濾清器--檢查
散熱器--清潔
蓄能器--檢查
窗戶清潔裝置貯水池--充滿
窗戶雨刮器--檢查/更換
每10工作小時或每日
備用報警--測試
鏟斗邊刀--檢查/更換
鏟斗斗齒--檢查/更換
冷卻液液位--檢查
機油油位--檢查
柴濾初級濾清器（油水分離器）--放水
油箱內水及沉淀物--排放
液壓油油位--檢查
安全帶--檢查
傳動系統油位--檢查
窗戶--清潔
每50工作小時或每周
下鏟斗銷軸承--潤滑
駕駛室空氣濾清器--檢查/更換
輪胎充氣--檢查
每100工作小時或每2周
車橋擺動軸承--潤滑
鏟斗聯接和裝載油缸軸承--潤滑
上鏟斗銷軸承--潤滑
圓木裝卸叉夾具--潤滑
轉向油缸軸承--潤滑
每250工作小時或每月
電池--清潔
皮帶--檢查/調整/更換
制動蓄能器--檢查
制動系統--測試
差速器及終傳動系統齒輪油油位--檢查
驅動軸花鍵（中部）--測試
發動機曲軸箱通氣孔--清潔
發動機機油（高速）和機油濾清器--更換
機油油位取樣--取樣
機油和機油濾清器--更換
最初500小時（適用于新系統，替換后系統，和維修后系統）
冷卻液系統冷卻液樣品（第2級）--取樣
每500工作小時
冷卻液系統冷卻液樣品（第2級）--取樣
每500工作小時或每3個月
差速器及終傳動系統齒輪油油位--檢查
發動機機油（高速）和機油濾清器--更換
發動機機油和機油濾清器--更換
燃油系統濾清器（油水分離器）--更換
油箱蓋和濾網--清潔
液壓油系統可降解濾清器--更換
液壓油油樣--取樣
傳動油濾清器--更換
傳動油油樣--取樣
每1000工作小時或每6個月
鉸接軸承--潤滑
電池接頭--緊固
驅動軸支撐軸承--潤滑
驅動軸接頭--潤滑
燃油二級濾清器--更換
蓋板翻轉調節器--潤滑
防護板鉸鏈--潤滑
防傾覆保護結構（ROPS）--檢查
轉向控制油濾網（控制轉向）--清潔/更換
傳動油--更換
每2000工作小時或一年
制動片--檢查
差速器傳動和終傳動油--更換
電器元件觸點--檢查/調整
發動機氣門間隙--檢查
發動機氣門轉閥器--檢查
液壓油--更換
液壓油箱呼吸安全閥--清潔
制動摩擦片磨損指示器--檢查
轉向軸（轉向控制）--潤滑
每年
冷卻系統冷卻液（第二級）--取樣
制冷干燥劑--更換
安裝后每3年或生產后每5年
安全帶--更換
每4000工作小時或每2年
液壓油--更換
每6000小時或每3年
冷卻液添加劑（ELC）--添加
冷卻系統水溫調節器--更換
每1200工作小時或每6年
冷卻液（ELC）--更換
When Required
Battery - Recycle
Battery or Battery Cable - Inspect/Replace
Bucket Wear Plates - Inspect/Replace
Circuit Breakers - Reset
Engine Air Filter Primary Element - Clean/Replace
Engine Air Filter Secondary Element - Replace
Engine Air Precleaner - Clean
Fuel System - Prime
Fuses - Replace
Oil Filter - Inspect
Radiator Core - Clean
Ride Control Accumulator - Check
Window Washer Reservoir - Fill
Window Wiper - Inspect/Replace
Every 10 Service Hours or Daily
Backup Alarm - Test
Bucket Cutting Edges - Inspect/Replace
Bucket Tips - Inspect/Replace
Cooling System Coolant Level - Check
Engine Oil Level - Check
Fuel System Primary Filter (Water Separator) - Drain
Fuel Tank Water and Sediment - Drain
Hydraulic System Oil Level - Check
Seat Belt - Inspect
Transmission Oil Level - Check
Windows - Clean
Every 50 Service Hours or Weekly
Bucket Lower Pivot Bearings - Lubricate
Cab Air Filter - Clean/Replace
Tire Inflation - Check
Every 100 Service Hours or 2 Weeks
Axle Oscillation Bearings - Lubricate
Bucket Linkage and Loader Cylinder Bearings - Lubricate
Bucket Upper Pivot Bearings - Lubricate
Logging Fork Clamp - Lubricate
Steering Cylinder Bearings - Lubricate
Every 250 Service Hours or Monthly
Battery - Clean
Belts - Inspect/Adjust/Replace
Brake Accumulator - Check
Braking System - Test
Differential and Final Drive Oil Level - Check
Drive Shaft Spline (Center) - Lubricate
Engine Crankcase Breather - Clean
Engine Oil (High Speed) and Oil Filter - Change
Engine Oil Sample - Obtain
Engine Oil and Filter - Change
Initial 500 Hours (for New Systems, Refilled Systems, and Converted Systems)
Cooling System Coolant Sample (Level 2) - Obtain
Every 500 Service Hours
Cooling System Coolant Sample (Level 1) - Obtain
Every 500 Service Hours or 3 Months
Differential and Final Drive Oil Sample - Obtain
Engine Oil (High Speed) and Oil Filter - Change
Engine Oil and Filter - Change
Fuel System Primary Filter (Water Separator) Element - Replace
Fuel Tank Cap and Strainer - Clean
Hydraulic System Biodegradable Oil Filter Element - Replace
Hydraulic System Oil Filter - Replace
Hydraulic System Oil Sample - Obtain
Transmission Oil Filter - Replace
Transmission Oil Sample - Obtain
Every 1000 Service Hours or 6 Months
Articulation Bearings - Lubricate
Battery Hold-Down - Tighten
Drive Shaft Support Bearing - Lubricate
Drive Shaft Universal Joints - Lubricate
Fuel System Secondary Filter - Replace
Hood Tilt Actuator - Lubricate
Roading Fender Hinges - Lubricate
Rollover Protective Structure (ROPS) - Inspect
Steering Pilot Oil Screen (Command Control Steering) - Clean/Replace
Transmission Oil - Change
Every 2000 Service Hours or 1 Year
Brake Discs - Check
Differential and Final Drive Oil - Change
Electronic Unit Injector - Inspect/Adjust
Engine Valve Lash - Check
Engine Valve Rotators - Inspect
Hydraulic System Oil - Change
Hydraulic Tank Breaker Relief Valve - Clean
Service Brake Disc Wear Indicator - Check
Steering Shaft (Command Control Steering) - Lubricate
Every Year
Cooling System Coolant Sample (Level 2) - Obtain
Refrigerant Dryer - Replace
Every 3 Years After Date of Installation or Every 5 Years After Date of Manufacture
Seat Belt - Replace
Every 4000 Service Hours or 2 Years
Hydraulic System Oil - Change
Every 6000 Service Hours or 3 Years
Cooling System Coolant Extender (ELC) - Add
Cooling System Water Temperature Regulator - Replace
Every 12 000 Service Hours or 6 Years
Cooling System Coolant (ELC) - Change
